Page 1
Access Control Terminal Quick Start Guide Important Notes Do not place the Access Control Terminal under strong light. Use regulated DC 12V/3A power source (supplied from control panel or separately purchased power supply). Do not place the Access Control Terminal in a vulnerable location where it might be subjected to vandalism.
Access Control Terminal Quick Start Guide 1. Features • Rugged structure for outdoor installation and extra durability * IP65 rated waterproof and dustproof structure • Fast and accurate fingerprint algorithm * Fingerprint identification in 1 second * Stores 3,000 fingerprint templates, 30,000 cards and 100,000 transactions •...
Access Control Terminal Quick Start Guide 9. Mounting the Unit • Locate the appropriate area for the unit. Place the unit approximately 5 ½ feet above the ground level so that the users are comfortable in using the unit with fewer chances of errors. •...
Access Control Terminal Quick Start Guide long beep. After that the system returns to verification state, the Green LED blinks once every two seconds (the buzzer has no beep). Note: You have to reboot device again to register management card if it’s operation timeout. You can use the Software to configure or modify the management card once it is registered.
Access Control Terminal Quick Start Guide 13. Delete an Ordinary User Swipe the management card by five times in a row to enter the single user deletion state. The Red LED blinks twice every three seconds, at the same time the buzzer has two short beeps every three seconds. •...