Table of Contents
Advertisement
Configuring the Relay Driver Module
Using this Chapter
Warnings and Cautions
WARNING
WARNING
Caution
This chapter shows how to configure and install the Relay Driver Module.
The chapter includes:
•
Warnings and Cautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 21
•
Relay Driver Module Configuration . . . . . . . . . . . . . . . . . . . page 22
•
Setting Relay Driver Module Operation . . . . . . . . . . . . . . . . page 26
•
Installing the Relay Driver Module . . . . . . . . . . . . . . . . . . . page 28
•
Verifying Initial Operation . . . . . . . . . . . . . . . . . . . . . . . . . . page 29
SHOCK HAZARD. Only qualified. service-trained personnel who
are aware of the hazards involved should install, configure or
remove the Relay Driver Module. Disconnect all power sources
from the mainframe and installed modules before installing or
removing a module.
SHOCK HAZARD. When handling user wiring connected to the
Relay Driver Module, consider the highest voltage present
accessible on any channel. Use wire with an insulation rating
greater than the highest voltage which will be present on any
channel.
MAXIMUM VOLTAGE/CURRENT. Maximum allowable voltage
per channel for the Relay Driver Module module is 32 VDC
and 200 ma per channel. Exceeding any limit may damage the
module.
STATIC-SENSITIVE DEVICE. Use anti-static procedures when
removing, configuring, or installing a module.
Configuring the Relay Driver Module
Chapter 2
21
Advertisement
Table of Contents
