Table of Contents
Advertisement
Configuring the Module
WARNING
Caution
Caution
12 Getting Started
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
This section provides general information to connect user wiring to the
breadboard module and provides guidelines for mounting components on
the module.
Note
This section does not describe installing the breadboard module in a carrier.
Since installation is dependent on the carrier used, you should refer to your
carrier's documentation for detailed installation instructions. Each Agilent
M-Module is supplied with identifying labels that should be installed on the
carrier.
SHOCK HAZARD. Only qualified, service-trained personnel
aware of the hazards involved should install, configure, or
remove the M-Module. Disconnect all power sources from the
mainframe, the terminal module and installed modules before
installing or removing a module.
VOLTAGE/CURRENT. Pay careful attention to the limitation of
maximum voltage/current and maximum power listed in
Appendix A. Exceeding any limit or use outside the parameters
specified may damage the module and/or carrier.
STATIC ELECTRICITY. Static electricity is a major cause of
component failure. To prevent damage to the electrical
components on an M-Module or the carrier, observe anti-static
techniques whenever installing, removing, or working on a
carrier or M-Module.
Advertisement
Table of Contents
