Table of Contents
Advertisement
Linking
Commands
SCPI Command Reference
.
Parameter Type
Numeric
Boolean
Discrete
Linking IEEE 488.2 Common Commands with SCPI Commands: Use a
semicolon between the commands. For example:
*RST;OUTP ON or TRIG:SOUR HOLD;*RST
Linking Multiple SCPI Commands: Use both a semicolon (;) and a colon (:)
between the commands. For example:
ARM:COUN 1;:TRIG:SOUR EXT
This section describes the Standard Commands for Programmable Instruments
(SCPI) commands for the Agilent E1339A/Z2309A Relay Driver Module.
Commands are listed alphabetically by subsystem and also within each subsystem.
There are two ways to send commands to the instrument. The most often used way
is from a controller over the GPIB interface. This method is referred to as the "GPIB
interface" in the command reference. The second way to send commands is from a
terminal connected to the Agilent E1406 command module (RS-232). Commands
sent this way will be referred to as "from the terminal" in the command reference.
Explanations and Examples
Accepts all commonly used decimal representations
of numbers including optional signs, decimal
points, and scientific notation. 123, 123E2, -123,
-1.23E2,.123, 1.23E-2, 1.23000E-01. Special cases
include MIN, MAX, and INF.
Represents a single binary condition that is either
true or false.
ON, OFF, 1, 0.
Selects from a finite set of values.These parameters
use mnemonics to represent each valid setting. An
example is TRIGger:SOURce <source> where
<source> can be BUS, EXT, HOLD, or IMM.
Relay Driver Module Command Reference
59
Advertisement
Table of Contents
