Note
Clearing the interface using a Ctrl-c from the terminal during a scan leaves the last
channel the scan closed in the closed position, and does not set the "scan complete"
status bit.
Related Commands: ARM, INITiate:CONTinuous, [ROUTe:]SCAN, TRIGger
Example
Example: Stopping a Scan With ABORt
Program
This example stops a (continuous) scan in progress.
TRIG:SOUR BUS
INIT:CONT ON
SCAN (@100:103)
INIT
.
.
ABOR
!Bus is trigger source
!Set continuous scanning
!Set channel list
!Start scanning cycle
!Abort scan in progress
Relay Driver Module Command Reference
61