Cisco Headset 560 Series Standard Base - Cisco 521 User Manual

Cisco Headset 560 Series Standard Base

The following table describes the Cisco Headset 561 and 562 Headset buttons.
Table 6: Cisco Headset 561 and 562 Buttons
Number Button
1
2
3
4 N/A
Cisco Headset 560 Series Standard Base
The standard base charges your headset and has LEDs that shows your headset's battery level and call state.
You can also answer and end calls when you lift or place your headset on the base.
Cisco Headset 500 Series User Guide
6
Name Description
Power and Call button Use to power the headset on and off.
Press and hold for 4 seconds to power the headset off and on.
Incoming and active call management depends upon if you have one
call or multiple calls.
One call:
Multiple calls:
Mute button Toggle the microphone on and off.
Volume buttons Adjust the volume on your headset.
LED Shows the headset status:
• Press once to answer incoming calls.
• Press once to put an active call on hold. Press again to retrieve a
call from hold.
• Press twice to reject an incoming call.
• Press and hold to end a call.
• Press once to put an active call on hold, and to answer a second
incoming call.
• Press once to put a call on hold. Press again to resume a call, or
press and hold until you hear a tone to end the current call and
to resume a held call.
• Press and hold until you hear a tone to end an active call, and to
answer another incoming call.
• Press twice to stay on a current call, and to reject a second
incoming call.
• Blinking red—Incoming call.
• Steady red—Active call.
• Blinking white—Firmware upgrade is in process or the headset
is pairing with the base station.
Your Headset