Cisco 521 User Manual page 15

Your Headset
Number
2
3
4
You select which call source you want to use with the call source controls on the Multibase. The LED next
to each selected source lights up when the source is selected.
Even if you are connected to a source, the LED may not be lit. The source LED only lights when the source
is selected or has an active call. For example, you may be properly connected to a Cisco IP Phone, your PC,
and your mobile phone through Bluetooth. However, the respective source LED is only lit when it is selected,
has an active call, or has an incoming call. Press the source button to check if a source is properly connected.
The source LED flashes three times if there is no connection.
You can alternate between active call sources.
Note
Place an active call on hold before you change to a different call source. Calls on one call source aren't
automatically put on hold when you switch to a different call source.
Name
Call Status LEDs
Mute Status LED
Bluetooth Status LED
Cisco Headset 560 Series Multibase
Description
Alerts you to the call state:
• Active Source—Steady white
• Incoming call—Blinking green
• Active call—Steady green
• Incoming call on an unselected source—Pulse green
Alerts you when your headset is muted.
Alerts you to the Bluetooth status:
• Paired with a call source—Steady white
• Pairing mode—Blinking white
• Searching for a call source—Pulse white
• Bluetooth is Off—LED is blank
Cisco Headset 500 Series User Guide
9