TechniSat Digitradio 361 CD IR User Manual page 57

> If you wish to enter your WLAN password manually, or if your router does not support the WPS function,
select Skip WPS.
> Enter your WLAN password using the r/s PRESET, VOL+, VOL- and ENTER buttons on the remote
control (7, 9, 8, 26, 27) or by rotating and pressing the SELECT/VOLUME knob on the device (5) and
confirm with OK.
The entered password is now verified. This process is generally completed after a few seconds and the
WLAN connection can now be used.
15.2.2.2 Configuration via the WPS function
This establishes a direct connection to the router. Selecting and/or entering a WLAN network (SSID) and
password is not required.
> Start the WPS function on your router as per the instruction manual.
> Then select PBC WLAN set-up to start the connection process.
Please observe the display overlays. The connection process is generally completed after a few seconds
and the WLAN connection can be used.
15.2.2.3 Manual configuration
> Select Manual settings followed by Wireless to start manual configuration.
> Now select whether you wish to automatically retrieve the IP address, gateway etc. on your router (DHCP
active) or to enter it manually (DHCP inactive).
Please take into account that automatic retrieval of the IP address, gateway, subnet mask etc. only
works if the DHCP function is activated in your router.
> In sequence, enter the IP address, subnet mask, gateway address, primary DNS and secondary DNS (if
required) using the r/s PRESET, VOL+, VOL- buttons.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
57