TechniSat Digitradio 361 CD IR User Manual page 27

4.4.1 Switching on the device
> Using the On/Standby button on the device (1) or on the remote control (1) you can switch on the
device or switch it back to standby.
After switching on for the first time, you can launch the set-up wizard (Section 15.7). Here you can set
the time format, time zone, summertime adjustment and the date and time updating (via DAB+, FM,
Internet or no update) using the r/s PRESET, VOL+, VOL- and ENTER buttons on the remote control
(7, 9, 8, 26, 27) or by rotating and pressing SELECT/VOLUME knob on the device (5).
The device will then attempt to find a connection to a network. To do so, select the corresponding
WLAN network or LAN [cable] and enter the WLAN password if required using the r/s PRESET, VOL+,
VOL- and ENTER buttons on the remote control (7, 9, 8, 26, 27) or by rotating and pressing the SELECT/
VOLUME knob on the device (5).
4.4.2 Operating the device with the remote control
With the infrared remote control you can operate the most important device functions from the comfort of
your armchair. When operating the device with the remote control, please take into account the following
points:
> Point the remote control towards the front of the device.
> There must be a line of sight between the remote control and the radio.
> If the range of the remote control reduces, replace the battery with a new one.
The maximum range is approximately 4 metres from the front of the device.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
27