Table of Contents
Advertisement
To install the SCSI I/O devices in the 8400:
1. Make sure that the shelf the devices are being placed in can be connected to the
same numbered hose connector as in the 8200.
2. Insert the devices in the same places in the 8400 shelf that they occupied in the
8200 shelf. (The left side of the 8200 shelf corresponds to the bottom of the
8400 shelf.) Press in on the mounting tabs (see
other hand to support the unit, slide the unit into the shelf until it connects.
3. Reconnect the I/O cable to the shelf and to the PCI adapter to which it was
originally connected (see
for reconnection.)
4. Connect the power supply cord (see
5. Move any other I/O devices or external controllers from the 8200 to the 8400
and cable them.
6. Return to page 19 to work on the next PCI card cage, and repeat the steps from
there to this page until all adapters and devices have been transferred from the
8200 to the 8400.
in Figure 11), and using the
). (Remember that you labeled adapters and devices
).
Procedure 25
Advertisement
Table of Contents
