Table of Contents
Advertisement
We assume here that the DWLPB PIUs have been installed in the 8400 system, and
that any extra PCI shelves have been installed as necessary, as described in the
DWLPA/DWLPB PCI PIU Installation Guide (EK-DWL84-IN).
1. Disconnect any power cables (see
shelf from being pulled out.
2. Remove the four Phillips head screws that hold the shelf in the PIU. See
3. Slide the shelf out until the slides lock.
4. Remove the side cover by loosening the two quarter-turn screws that hold the
shelf in place, tilting the top of the cover away from the shelf and then lifting
the cover off the shelf (see
5. Remove the face plates from any slots you plan to use for PCI or EISA options.
The face plates are held in place by a Phillips head screw on the inside right
front edge of the card cage.
6. Insert the option boards (see
7. Attach the hose I/O cable to the proper KFTIA/KFTHA connector (remember
that you labeled them, as described on page 9), and to the PCI card cage whose
contents you just transferred.
8. Proceed to the next page.
in Figure 9), that will prevent the PCI
).
).
.
Procedure 21
Advertisement
Table of Contents
