GIRA
Continuous Controller
Instabus
Info
Installation Instructions
Instabus Continuous Controller
System Information
This device is a product of the Instabus EIB-system and complies with EIBA directives. Detailed
technical knowledge obtained in Instabus training courses is a prerequisite to proper understanding.
The functionality of this device depends upon the software. Detailed information on loadable software
and attainable functionality may be taken from the manufacturer's product database.
Planning, installation and commissioning of the unit is done by means of EIBA certified software.
Function
The Instabus EIB continuous controller can be used for single-room temperature control. A continuous
control signal for directly triggering an Instabus actuating drive, for example, or a switching corrective
signal for triggering a dual 6 A Instabus switching actuator in connection with an electrothermic
actuating drive is alternatively possible.
Properties
Depending upon the setting, PI control, P control, two-position control or pulse width modulation PWM
•
Heating and / or cooling with manual or automatic change-over and common or separate control
outputs are possible
•
Two-stage heating or cooling operation
•
Five different operating conditions with their individual set values
•
Comfort mode continuation or change of mode by presence push-button
•
Variable frost and heat protection
•
Externally triggerable objects for presence push-button, automatic timer, door / window contact
and controller locking
•
Acting-sense change-over via Instabus EIB
•
Controller status as well as set and actual values are accessible through Instabus EIB
•
Five LEDs to indicate the operating states
•
Malfunction indication by mode LED
•
Set value shifting by a maximum of ± 10 K possible by control knob and software
•
Locking the controls for protection against unauthorised use possible
•
Temperature alignment for Powernet applications.
Powernet Continuous Controller
19/99
Order No.: 0566 ..
Page: 1 of 3