Install the HP-FL
peA
WARNING
Slot selection depends on how your system is configured. Review the section
titled "HP-FL Subsystem Considerations" in chapter 1. Your system
administrator's manual will identify those slots where the
HP-FL PCA
is allowed.
Switch off the computer power when installing or removing a
peA.
Before switching off the power, carefully follow the shutdown
procedures explained in your system manuals.
Failure to follow the correct procedure may result in electrical shock
and in data loss or corruption.
The
HP-FL PCA
must be installed into the
CIO
card cage of your computer or
extender unit. Because this operation is system dependent, refer to the system
hardware manuals supplied with your computer for details. You will:
1.
Shut down the operating system.
2.
Switch off the computer power.
3.
Open the
CIO
card cage.
4.
Insert the
PCA
into a
CIO
card cage slot. This step includes orienting
the
peA
correctly, and seating the
PCA
connector onto the backplane
connector in the
CIO
bus. However, do not insert the PCA completely
into the backplane connector. Leave about 5 cm (2 in.) protruding to
allow installation of the fiber-optic cable.
Installation and Configuration 2-3