No Drill Zones Rear Cargo Area - Ford TRANSIT 2016.75 Mounting Manual

Ford released hardware is available to support
further installations to the vehicle. Only this
hardware and released parts are to be used for
this.
4.1.12 No Drill Zones
Precautionary Drill Zones L2/H2
E167561
CAUTION: Do not drill into the vehicle
before checking the precautionary drill
zones and electrical wire routing.
The areas marked in blue on figures E167561 -
E167565 show the Precautionary Drill zones for
the rear cargo area where there is wire routing and
is to be avoided, (for example: when installing
cladding and racking). The same care should also
be taken when using self-tapping screws. Not all
derivatives are shown but the routing is the same
for roof line and wheel base with regards to 'B',
'C' and 'D' pillars or roof bows and doors. Other
non-electrical systems may also be present, for
example: fuel tank under floor so it is important
to check before drilling. For additional information
refer to the following links.
Refer to: 5.1 Body (page 227).
EU FORD TRANSIT 2016.75
Rear Cargo Area
Rear Cargo Doors
Precautionary Drill Zones
Refer to: 5.4 (page 258).
Load Compartment Tie Downs
Refer to: 5.3 Racking Systems (page 255).
Refer to: 5.6 Body Closures (page 261).
No Drill Zones - Closures
For vehicle wheelbase and Roof height
Refer to: 1.14 Package and Ergonomics (page 30).
'Vehicle Dimension Key' in this manual
Date of Publication: 03/2018
89