Ford TRANSIT 2016.75 Mounting Manual page 37

A Maximum recommended rear overhang
B Back of cab to rear
axle
C Maximum external
body width
D Maximum recommended external
overall height RWD and FWD
E 30mm minimum clearance between the back of the cab and the second unit body
F 30mm
G Ensure local lighting legislation is maintained
H Under run bar and towing attachment legislation to be maintained
J Frame length behind
back of cab (not
including rear light
cross member)
K Departure angle
NOTE: The frontal area (Width x Height) should NOT exceed 6.4m².
CoG = Center of Gravity
All dimensions are subject to manufacturing tolerances and refer to minimum specification models
and do not include additional equipment. The illustrations are for guidance only.
* The maximum width of a vehicle conversion may be restricted below 2400mm in order to comply
with installation of Lighting Regulation ECE R48 which specifies widths restrictions for mandatory light
components. Fitting optional Front Fog Lamps restricts the vehicle width to 2375mm. For non-European
Union territories, please refer to local legislation. For Australia and New Zealand, please refer to ADR43
vehicle regulations.
EU FORD TRANSIT 2016.75
Description
Single Cab
Double Cab
Short Mirror
Arms
Long Mirror
Arms
Single Cab
Double Cab
L1 L2
Maximum 50% of the wheelbase considering CoG of
(second unit) body and payload is not rearwards of
rear axle centerline and considering the requirements
of masses and dimensions regulation
1730mm 2097mm 2547mm
- 1282 1732
2200mm
Maximum widths of up to 2400mm*
3300mm without exceeding the maximum CoG height.
See Load Distribution section in this manual for CoG
Position
2775mm 3142mm 3592mm
- 2327
It is recommended to ensure that a minimum departure
angle of 14° at RGAWR of the converted vehicle and
for any additional part of the conversion is maintained.
L3 L4 L5
2547mm 3115
1732 2300
4149mm 5147
2777 3159 4149
Date of Publication: 03/2018
37