3.7 Exhaust System
3.7.1 Extensions and Optional
Exhausts
CAUTIONS:
Non-standard systems must be tested
for engine back pressure and all legal
compliance (noise and emissions).
Exhaust Pipe Design Principles
Item
d
diameter
r
radius = 2.5d
3.7.2 Exhaust Pipes and Supports
CAUTIONS:
Maintain the original set-up and heat
shields.
Do not position any components closer
than 150mm nominal (100mm minimum)
clearance to the downpipe, the catalytic
converter, the diesel particulate filter,
the selective catalyst reduction and any
part of the exhaust system.
EU
FORD TRANSIT 2016.75
E74569
Description
Make sure that for any pipes that require
bending, the radius of the bend is
minimum 2.5 x tube diameter.
Make sure that sufficient clearance is
maintained for all driving conditions to
all hot and moving components.
NOTE: Where possible all pipe connections
should be designed so that the gas flows from
smaller to larger diameter pipes.
d
3.7.3 Exhaust Heat Shields
Exhaust Heat Shields
• Catalytic converters, in particular, operate at
high temperatures.
• Ensure existing shields are maintained.
• Add further shields over exhaust system as
necessary to avoid fire risk.
Date of Publication: 03/2018
79