Advertisement
Quick Links
© Panduit Corp. 2004
Important Notice:
Should Fan Kit P/N IAEFK54 be integrated into the enclosure, P/N IAEIP66, the IP rating of the enclosure
shall be reduced to IP54. If the enclosure and any active equipment is located in an environment containing conductive
particles that have the potential to cause sparks and shorts, or the enclosure is placed in an environment that contains
ignitable dust or explosive gases, in this scenario the IP rating of the enclosure shall be reduced to IP44. Before any
application in these last cases, the installer should insure that all requirements, legal and industry, are met and
precautions are taken to meet the installation requirements of the equipment placed inside the enclosure.
List of Components:
(1) 24 VDC Power Supply
(3) T
-T
AK
YS
(6) Adhesive Backed Mounts
(6) P
-T
AN
YS
(1) Electrical Hole Seal
(1) Port ID Label
(3) 10 AWG Grounding Cables
(1) 12 AWG Grounding Cable
(1) 35mm DIN Rail
(1) #10-32 x 1/2" Pan Head Screw
(3) #10 Spring Lock Washer
(2) #10-32 Hex Nut
35mm DIN Rail
Opening for 1/2"
Conduit Fitting
Opening for Industrial
Enclosure Gland Plate
For Technical Support: www.panduit.com/resources/install_maintain.asp
Industrial Automation Enclosure
INSTALLATION INSTRUCTIONS
(view shown with door removed)
Page 1 of 5
Part Number: IAEIP66, IAEFK54
CM296A
IAEIP66
Inner Panel
Cover Plates for Fan
and Exhaust Filter
Openings
Advertisement
Related Manuals for Panduit IAEIP66
Summary of Contents for Panduit IAEIP66
-
Page 1: Important Notice
© Panduit Corp. 2004 Important Notice: Should Fan Kit P/N IAEFK54 be integrated into the enclosure, P/N IAEIP66, the IP rating of the enclosure shall be reduced to IP54. If the enclosure and any active equipment is located in an environment containing conductive particles that have the potential to cause sparks and shorts, or the enclosure is placed in an environment that contains ignitable dust or explosive gases, in this scenario the IP rating of the enclosure shall be reduced to IP44. -
Page 2: Step 1: Power Supply Installation
Make sure the louvers are angled toward the bottom of the enclosure. (Previously installed cables removed from view for clarity) 3.4 Install the Thermostat to the DIN rail of the enclosure. For Technical Support: www.panduit.com/resources/install_maintain.asp Page 2 of 5... - Page 3 5.2 Connect the hot wire to the "L" on the input side of the power supply. 5.3 Connect the neutral wire to the "N" on the input side of the power supply. For Technical Support: www.panduit.com/resources/install_maintain.asp Page 3 of 5...
-
Page 4: Inner Panel
#10-32 x 1/2" Pan Head Screw and #10 Spring Lock Washer. 12 AWG Ground Cable Secure Cables Here 10 AWG 10 AWG Ground Ground Cable Cable Inner Panel For Technical Support: www.panduit.com/resources/install_maintain.asp Page 4 of 5... -
Page 5: Step 7: Patch Cord Installation
(Switch) Patch Cord E-mail: For Instructions in Local Languages cs@panduit.com and Technical Support: Fax: www.panduit.com/resources/install_maintain.asp www.panduit.com (708) 444-6993 Page 5 of 5...