Final Operations - Smeg Gas Cooktop PA106SX Instructions For Installation And Use Manual

Instructions for the installer

9. FINAL OPERATIONS

Follow the instructions given in paragraph "5.1 Removing the hob", but in the
reverse order.
When replacing the burner rings, remember that they have to be tightened
completely by means of the wrench supplied, otherwise the flame interruption
zones on the flame crowns will not be aligned with the grid spokes.
When positioning the grids, make sure that the pins are
aligned with their seats in the surface, then press them in
with the palm of your hand until they lock in place.
9.1 Adjusting the minimum for natural gas
Reposition the components on the burner and
slide the knobs onto the tap rods.
Light the burner and set it to the minimum
position .
Extract the knob again and turn the adjustment
screw inside or next to the tap rod (depending
on the model) until the correct minimum flame
is achieved.
Refit the knob and verify that the burner flame
is stable (when turning the knob rapidly from
the maximum to the minimum position the
flame must not go out).
9.2 Adjusting the minimum setting for LPG
To adjust the minimum setting with LPG, you must tighten the screw inside or
next to the tap rod (depending on the model) fully in a clockwise direction.
The diameters of the by-passes for the individual burners are given in the table
"10.3 Burner and nozzle characteristics tables".
9.3 Lubrication of gas taps
Over time the gas taps may become difficult to turn and get blocked. Clean them
internally and replace the lubrication grease. This procedure must be carried
out by a specialised technician.
23