Final Operations - Smeg SDR575XG5 Instructions For Use Manual

Instructions for the installer
6

FINAL OPERATIONS

Having carried out the above adjustments, reassemble the appliance
following, backwards, the instructions in paragraph "5.1 Removing the
hob".
6.1 Regulation of minimum for natural gas
Replace the components on the burner and
slide the knobs on the gas tap pins. Light the
burner and set it at minimum position. Remove
the knob and turn the regulation screw inside or
next to the gas tap pin (depending on the
model) until you get a suitable minimum flame.
Replace the knob and check burner flame
stability: (rapidly
maximum to minimum position, the flame
should not go out).
6.2 Regulation of minimum for LPG
To regulate the minimum for LPG, completely tighten (clockwise) the
screw inside or next to the gas tap pin (depending on the model).
The diameters of the by-passes for each burner are given in table "5.2
Regulation for LPG".
After having regulated the device with a gas other than the one tested,
replace the label located on the bottom enclosure with the one that
corresponds to the new gas. The label is inside the bag that contains
the nozzles.
turning the knob from
33