Table of Contents
Advertisement
Instructions for the installer
7. POSITIONING OF THE HOB
The following operation requires building and/or carpentry work so must be carried out by
a competent tradesman.
Installation can be carried out on various materials such as masonry, metal, solid wood or
plastic laminated wood as long as they are heat resistant (T 90°C).
7.1
Fixing to a support structure
Create an opening with the dimensions shown in the figure in the top surface of the
counter, keeping a minimum distance of 50 mm from the rear border.
This appliance is classified as "type Y" in relation to fire hazards and can therefore be
mounted against walls higher than the work surface on condition that a certain distance
"X" be kept between the appliance and the wall as shown in the figure so as to avoid
damage from overheating. Make sure there is a minimum of 600 mm between the hot
plate flames and any shelf that may be installed directly above them. In case of installation
on a hollow compartment with doors, a separating panel has to be placed under the hob.
Keep a minimum distance of 10 mm between the bottom of the unit and the panel surface.
The panel has to be easily removable to allow access in the event of technical service.
14
Advertisement
Table of Contents
