Important Safety Instruction 1. IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS – Your Safety And the Safety of Others Are Very Important. We have provided many important safety messages throughout this manual and on your appliance. Read all instructions before using your appliance and always obey all safety messages. RECOGNIZE SAFETY INFORMATION This is a safety alert symbol.
Instructions for the Installer 3. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTS NOTE: The following operation requires building and/or carpentry work and must therefore be carried out by a competent technician. Installation can be carried out on various material, such as masonry, metal, solid wood, plastic laminated wood etc.
Page 5
Instructions for the Installer Cooktop MINIMUM DISTANCE widht ” ” - 22 ” 19”- 19 ” ” ” ” ” ” 600 mm 565 - 569 mm 483 - 485 mm 210 mm 86 mm 36 mm 45 mm 600 mm ”...
Instructions for the Installer 3.1 Gas supply requirements EXPLOSION HAZARD Use a new AGA- or CSA-approved gas supply line. Install a shut-off valve. WARNING Securely tighten all gas connections. lf connected to LP, have a qualified technician ensure that gas pressure does not exceed a 14"...
Instructions for the Installer The regulator must be checked at a minimum water column of at least 1” (2.5 cm) above the set pressure. The inlet pressure to the regulator should be as follows for operation and monitoring of the regulator setting: - NATURAL GAS: Set pressure at 6”...
Page 8
Instructions for the Installer 3.2.1 Recommended Grounding Method For your personal safety, this cooktop must be grounded. This cooktop is equipped with a 3-prong ground plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-prong ground-type outlet, grounded in accordance with the National ANSI/NFPA 70 Electrical Code (latest edition*) or the Canadian Electrical Code (CSA)** and local codes and ordinances.
Instructions for the Installer 4. INSTALLING THE COOKTOP Remove the upper polystyrene guard and the side guards. Remove the grids, the nylon sheet serving to protect the cooktop during shipping and the burner crowns. These parts could make product assembly more difficult. Connection to the gas mains may be made with a flexible metal pipe and conforming to the provisions defined by current standard regulations in force.
Page 10
Instructions for the Installer Secure the cooktop to the counter with brackets A (supplied). Carefully trim any excess from edge B on the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket. The diagram below shows the exact positions of the holes to be used for clamping the hob to the top by the brackets correctly.
Page 11
Instructions for the Installer Always use pipe-joint compound made for use with NATURAL GAS and L.P. GAS between pressure regulator D and adaptator C and between pressure regulator D and pipe E. If flexible metal conductor is used, be certain tubing is not kinked. Use only pipes (E) conforming to standard regulations in force, inserting gasket B (supplied) between fitting A adaptator C.
Instructions for the Installer 5. CHECKING OPERATION After having fastened the top to the support structure, some simple procedures are required to check for proper operation. Check for any gas leaks in the vicinity of the cooktop connector, the pressure regulator and the safety valve.
Instructions for the Installer 6. WIRING DIAGRAMS The power cord on this appliance is equipped with a threee pronge polarized plug (grounding) which mates with standard three pronged (grounding) wall receptacles. Label all wires prior to disconnection when servicing controls. WARNING Wiring errors can cause improper and dangerous operation.
Page 14
Instructions for the Installer The power cord on this appliance is equipped with a threee pronge polarized plug (grounding) which mates with standard three pronged (grounding) wall receptacles. Label all wires prior to disconnection when servicing controls. WARNING Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.
Page 15
Instructions for the Installer The power cord on this appliance is equipped with a threee pronge polarized plug (grounding) which mates with standard three pronged (grounding) wall receptacles. Label all wires prior to disconnection when servicing controls. WARNING Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.