Installing An Hy Card; Removing The Hy Card - Yamaha Rivage PM10 Owner's Manual

Installing an HY Card

1.
Make sure that both power indicators are off.
Caution
Installing or removing a card while the power is on may
lead to component failure or electric shock.
2.
Remove the screws that fasten the slot cover
to remove the slot cover.
Keep the cover and fixing screws in a safe place for
future use.
3.
Align both edges of the HY card with the
guide rails inside the slot, and then insert the
card into the slot with the card installation
lever pressed down.
Push the card all the way into the slot so that the
connector at the end of the card is correctly inserted
into the connector inside the slot.
NOTE
For information on which cards support each slot, refer to
"Part Names and Functions" on page 11.
Slot cover
Card
4.
Pull up the card installation lever to lock in the
card.
Make sure that the lever claw is securely locked under
the bottom part of the slot.
NOTE
If the lever claw does not lock in, pull up the card slightly,
then push it in.
5.
Affix the card using the screws that were
previously used to affix the slot cover.
If the card is not fastened securely, component failure
or malfunction may occur.

Removing the HY Card

1.
Make sure that both power indicators are off.
Caution
Installing or removing a card while the power is on may
lead to component failure or electric shock.
2.
Remove the screws that hold the card in
place.
3.
Unlock the card by pressing the red button on
the card installation lever.
4.
Press down the card installation lever to pull
out the card.
5.
Replace the stored slot cover and affix it with
the screws.
RPio622 Owner's Manual 15