Advertisement
S T E P
7
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of Each Step. Some components may be pre-as-
sembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench tighten to
fully go on.
7A. Attach Short Metal Shrouds (WB) and Long Metal Shrouds (WC) to
Weight Stack Frame (WA) using:
4 - (#13) M8X25mm Button Head Cap Screw
8 - (#52) M8 Flat Washer
4 - (#42) M8 Nylon Lock Nut
7B. Bend the Plastic Shrouds (WD & WF) and insert them to the side
slots of the Metal Shrouds (WB & WC).
7C. Attach Top Shroud (WE) to Weight Stack Frame (WA) using:
3 - (#16) M6X16mm Phillips Head Screw
3 - (#53) M6 Flat Washer
34
Advertisement
