Advertisement
S T E P
3
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten unless instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
3A. Attach Cross Frame (G) to Weight Stack Frame (WA) using:
2 - (#9) M10x30mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#41) M10 Nylon Lock Nut
3B. Attach Cross Frame (G) to Right & Left Top Frame (E & F) using:
4 - (#5) M10x80mm Hex Head Bolt
8 - (#51) M10 Flat Washer
4 - (#41) M10 Nylon Lock Nut
2 - (#79) Steel Plate
3C. Install Chrome Guide Rods (N) into the holes of the Base Frames
(A & B).
3D. Install Rubber Donuts (#87) and slide to the bottom of the Guide Rods
(N).
3E. Tilt Guide Rods (N) forward and install Carriage (P) onto the Guide
Rods (N).
3F. Attach Guide Rods (N) to Right & Left Top Frame (E & F) using:
4 - (#14) M8x25mm Socket Head Cap Screw
2 - (#90) Guide Rod Retainer Half
26
Advertisement
