Advertisement
S T E P
6
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of Each Step. Some components may be pre-as-
sembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench tighten to
fully go on.
6A. Install Cable (#74) by first assembling the ball end into the Selector
Rod Top Bolt (#73) and attaching the Quick Cable Lock (#72) over
the ball end of the cable. Secure it by tightening the Set Screw (#18)
6B. Install the M10X35mm Hex Head Bolt (#8) through the slot hole of the
Selector Rod Top Bolt (#73) by fastening the M10 Nylon Lock
Nut (#41).
6C. Route Cable (#74) while installing two Pulleys (#76) into Frames (WA
& G) as shown in Step 6 Drawing using
2 - (#4) M10X50mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#41) M10 Nylon Lock Nut
6D. Attach the end of the Cable (#74) to Cable Connector (#66)
6E.
Attach Cable Connector (#66) to Carriage (P) using:
1 - (#7) M10X45mm Hex Head Bolt
2 - (#51) M10 Flat Washer
1 - (#41) M10 Nylon Lock Nut
1 - (#89) Sleeve (Shrink Wrapped with #66)
32
Advertisement
