Advertisement
S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten unless instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
2A. Attach Right Top Frame (E) to Weight Stack Frame (WA) using:
2 - (#3) M10x105mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#41) M10 Nylon Lock Nut
1 - (#77) 170x50x6mm Steel Plate
2B. Attach Right Top Frame (E) to Right Upright (C) using:
2 - (#3) M10x105mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#41) M10 Nylon Lock Nut
1 - (#78) 280x50x6mm Steel Plate
2C. Attach Left Top Frame (F) to Weight Stack Frame (WA) using:
2 - (#2) M10x105mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#41) M10 Nylon Lock Nut
1 - (#77) 170x50x6mm Steel Plate
2D. Attach Left Top Frame (F) to Left Upright (D) using:
2 - (#3) M10x105mm Hex Head Bolt
4 - (#51) M10 Flat Washer
2 - (#41) M10 Nylon Lock Nut
1 - (#78) 280x50x6mm Steel Plate
24
Advertisement
