Table of Contents
Advertisement
3
First Time Easy Install
The quick install guide will prompt you to program the basic system in easy steps.
i
• Any omissions or mistakes can be rectified
later. Once the first time install has been
successfully completed it will not be shown
again.
• More advanced programming can be done
at a later stage including adding and naming
sensors and changing various settings.
The control panel will beep and "Set user code (OK?)"
will be shown, and the green LED will be on.
Move rightwards to lock and move leftwards to release
the panel (panel top facing the user). Using a pointed
tool, slide the battery switch to the right in the direction of
the arrow to switch the internal battery.
The panel is now ready for the first time
installation steps:
1. Set user code (OK?)
Press
3
2. Enter 1st code ....
Enter a four digit PIN code. Press
X can be use to correct wrong number.
Make a note of the entered code, it will be
required later.
3. Set 2nd code Y/N
Select No to skip, Yes to enter 2nd code.
Maximum 3 set of codes can be set.
The current selection is shown by the
flashing dot on the far LEFT. Use p/q keys
to navigate.
6
Unpack the kit
content on a
table. Remove the
mounting plate
(if fitted) from the
control panel. Move
rightwards to lock
and move leftwards
to release the panel
(panel top facing the
user). Connect the
power adaptor.
3
4. Reset code / Next step
Select reset code to repeat step 2, or next
step to proceed.
Cursor is on NEXT STEP as default
5. Add Device (OK?)
Press
3
6. Push button on Device to Add
PRESS
PRESS
PRESS
Battery
Y
ale
R
cover
Coin
1
2
3
slot
4
6
5
9
7
8
Locked
0
Unlocked
Keypad
(Keys should be pressed positively within 3 secs of the
previous press)
1 Press
and enter
Panic button A
0000
(The LED will now be flashing. System is now in setting mode)
2 Press
and enter
Panic button A
7
(The keypad will confirm with two fast flashes that it is in "Siren as master"
mode.)
3 Press
then
to send learn-in signal, then
Panic button A
1
press
twice to quit.
disarm
7. Detect (OK?)... Zone01 B
Press
3
to confirm
Devices are labeled by the following codes:
· Door Contact
DC
· PIR Sensor
IR
· Smoke Sensor
SD
· Remote Controller
RC
· Remote Keypad
KP
· Help Button
FP (Fix-Panic)
8. More device / Next step
If you have more device to add to the system,
select More devices (this will go back to step
6), or select Next step to move forward.
PRESS
PRESS
Yale
Hide quick links:
Advertisement
Table of Contents
