Table of Contents
Advertisement
Mounting the Door/ window Contact
Frame
Sensor
Gap approx 10mm
Gap no more
than 8mm
1 Find a location where the door/window contact
is to be mounted. It should be mounted between
the door/window frame and the door/window as
shown at the top of the opening. The magnet is to
go on the door/window while the sensor is to be
placed on the frame. Windows can be protected
in a similar way to doors. Make sure the tamper
switch spring is fully depressed.
i
The gap between the magnet and sensor should
be approximately 10mm when closed (depending
upon the actual environment).
Simple test to see whether the magnet is in range
of the sensor: hold the magnet and sensor in
place and then pull them apart. If the sensor LED
lights up it implies the two items are within range.
Mounting using adhesive pads
1 Clean the mounting surface with a suitable
degreaser agent.
2 Remove the protective film from one side of the
adhesive pad and apply to the back of the sensor
and magnet. Remove the remaining protective film
and firmly press into place.
3 Test sensor by pressing the test button and
opening and closing the door/window. The LED
should light when the door/window is opened.
Installation is complete.
Mounting using screws and wall plugs
1 Loosen the bottom screw and open the door/
window contact.
2 Knock out the holes on the base as shown.
Door/Window
Magnet
3 Drill holes into the mounting surface using the
holes in the knockouts on the base as template.
4 Fit wall plugs (if required)
and secure with the screws
provided.
5 Fit sensor back together and
tighten screw.
6 Test sensor by pressing the
test button and opening
and closing the door/
window. The LED should
light when the door/window is opened. Installation
is complete.
Mounting the Help button
1 Break through the knockouts (where the plastic is
thinner).
2 Using the holes as a template, drill holes in the
surface and insert wall plugs if fixing into plaster or
brick. Screw the rear case to the wall.
3 Replace the cover and tighten the screw.
Mounting the Smoke Detector
1 The base has two mounting slots. Using the slots
as a template, drill holes and insert the wall plugs if
fixing to plaster. Screw the rear case to the ceiling
using the screws provided.
2 Replace the cover.
i
Final step:
After mounting the siren and detectors,
please enable the system tamper by:
1 Press the
key and enter a user PIN
code followed by 3.
2 The control panel is now in programming
mode, Select Devices +/-, then Program
Siren and Siren Tamp. On using the pq3
keys.
3 Press 3 when in the Siren Tamp. On menu
and the control panel will beep followed by
an acknowledgement pip from the siren.
4 Quit programming mode and system
tamper protection will be automatically
restored.
Knockouts
11
Hide quick links:
Advertisement
Table of Contents
