Configuring And Viewing Setup Information - 3Com OfficeConnect 3C16710 User Manual

16710.bk : MANVT100.FRM Page 10 Tuesday, October 7, 1997 11:38 AM
5-10 C 5: A M
H A P T E R D D I T I O N A L A N A G E M E N T
Configuring and Viewing Setup
Information
The Management Setup screen, as shown in
Figure 5-5 , is used to configure IP, IPX and SLIP
parameters for the hub. This screen also provides
access to other screens for you to set up traps and
console port parameters.
If you have no previous knowledge of IP, refer to
Appendix B for more information.
Figure 5-5 Management Setup Screen
U VT100
S I N G
MAC Address The MAC address of the hub. This
cannot be changed.
Device IP Address If using IP, you need to enter a
unique IP address for the hub, see "IP Addresses" on
page B-1 . You may use the BOOTP facility (see the
BOOTP Select field description) if your network has a
BOOTP server, or enter it manually. If you change the
device IP address, you must reset the hub to effect
the change.
CAUTION: To ensure that Quick Config Manager can
always communicate with the hub, the IP subnet
192.168.101.x is permanently assigned to the SLIP
port in addition to the user configurable SLIP
address. Do not use this subnet for your Ethernet
(network).
Device SubNet Mask If using IP, enter a suitable
subnet mask. BOOTP does this automatically. For a
class B IP address, 255.255.0.0 is suitable. If you
change this field, reset the hub to effect the change.
Default Router If necessary, enter the IP address of
the default router on your network. BOOTP does this
automatically. If you change this field, reset the hub
to effect the change.