3Com OfficeConnect 3C16710 User Manual page 90

16710.bk : MANVT100.FRM Page 14 Tuesday, October 7, 1997 11:38 AM
5-14 C 5: A M
H A P T E R D D I T I O N A L A N A G E M E N T
Figure 5-7 Console Port Setup Screen
If you alter the console port settings and select OK ,
you terminate any existing session using the console
port. To avoid terminating the session completely ,
ensure that the settings are correct and that the
connected equipment's settings match the new
configuration.
If you change the console port parameters with
Auto Config already set to Enabled, or if you change
Auto Config to Enabled, you need to perform the
wake-up procedure before communication is
re-established, see "Main Banner" on page 5-6 .
U VT100
S I N G
If you are unsure of the correct settings to use, refer to
the manual for your terminal or modem. If you
change the settings by accident, return them to their
default settings (shown on these pages as the
underlined values).
Serial Connection Terminal / Modem
Select Modem i f you want to manage the hub
through a modem. Otherwise, leave as Terminal.
The cable you require for connecting a modem is
shown in "Cabling" on page A-2 .