Using The Rubber Feet And Stacking Cl Ips - 3Com OfficeConnect 3C16710 User Manual

16710.bk : CREYRNET.FRM Page 6 Tuesday, October 7, 1997 11:38 AM
2-6 C 2: C Y
H A P T E R R E A T I N G O U R

Using the Rubber Feet and Stacking Cl ips

The four self-adhesive rubber feet prevent your hub
from sliding around on your desk. Stick the feet to
the marked areas at each corner of the underside of
your hub.
The four stacking clips are used for neatly and
securely stacking your OfficeConnect units together.
You can stack up to a maximum of four units.
Large units must be stacked below small units.
To stack your units, secure the clips on one side and
then on the other. Use the following method to
secure one side:
1 Place your new unit on a flat surface. Your clips fit in
the positions on the side of the unit, as shown in
Figure 2-3 (1).
2 Position a clip over one of these holes and push it in
until it clicks into place, as shown in Figure 2-3 (2).
Repeat this for the other clip position on the same
side.
3 Keeping the front of the units aligned, rest the
bottom of the existing u nit on the clips' spikes, as
shown in Figure 2-3 (3). Push the clips firmly into the
existing u nit until they click into place.
N
E T W O R K
Figure 2-3 Clipping Your Units Together
Repeat these steps to secure the other side.
To remove a clip, hold the units firmly with one
hand and hook the first finger of your other hand
around the back of the clip. Use reasonable force to
pull it off.