3Com OfficeConnect 3C16710 User Manual page 63

16710.bk : MANAGING.FRM Page 27 Tuesday, October 7, 1997 11:38 AM
5 Select either Enable or Disable for Link Traps,
Partition Traps, and Learn Stations.
Click on OK .
6
In the Repeater Port Info panel:
Media Type Shows the type of media connected to
the port.
Partition State Shows whether the port is on and
repeating traffic, or has been automatically isolated
(partitioned). If the port has partitioned check the
cabling at both the port and any devices connected
to the port, and check for network loops.
Link State Shows the state of the link for a twisted
pair (10BASE-T) port.
Port State Enabled / Disabled
S elects whether the port can repeat information to
and from the network.
Link Traps Enabled / Disabled
Selects whether a trap is sent to an IP/IPX-based
network management application if the link state
changes.
Configuring a Port
Partition Traps Enabled / Disabled
Selects whether a trap is sent to an IP/IPX-based
network management application if the partition
state changes.
Learn Stations Enabled / Disabled
Selects whether the source address of received
frames is learned.
Attached Station Shows the MAC address of the
device attached to this port (the last device to
transmit to this port).
The check boxes in the View Port box enable you to
display statistics for the port and are described in
"Monitoring" on page 4-18 .
The View Station box is always disabled for Quick
Config Manager.
4-27