I
C
NITIAL
ONFIGURATION
The switch's console menu, Web Interface, and SNMP agent allow you to
perform the following management functions:
•
Set user name and password
•
Set an IP interface for management access (console menu only)
•
Configure SNMP parameters
•
Enable/disable any Ethernet port
•
Set the speed/duplex mode for any port
•
Configure up to 255 IEEE 802.1Q VLANs
•
Enable GVRP automatic VLAN registration
•
Configure IGMP multicast filtering
•
Upload and download system firmware via TFTP
•
Upload and download switch configuration files via TFTP
•
Configure Spanning Tree parameters
•
Configure Class of Service (CoS) priority queuing
•
Configure up to four static or LACP trunks
•
Enable port mirroring
•
Prevent broadcast storms by limiting bandwidth for broadcast traffic
•
Display system information and statistics
Required Connections
The switch provides an RS-232 serial port that enables a connection to a
PC or terminal for monitoring and configuring the switch. A null-modem
console cable is provided with the switch.
Attach a VT100-compatible terminal, or a PC running a terminal
emulation program to the switch. You can use the console cable provided
with this package, or use a null-modem cable that complies with the wiring
assignments shown in the Installation Guide.
To connect a terminal to the console port, complete the following steps:
1. Connect the console cable to the serial port on a terminal, or a PC
running terminal emulation software, and tighten the captive retaining
screws on the DB-9 connector.
2-2