C
L
OMMAND
INE
Minimum Abbreviation
The CLI will accept a minimum number of characters that uniquely
identify a command. For example, the command "show" can be entered as
sh. If an entry is ambiguous, the system will display a help message.
Getting Help on Commands
You can display a brief description of the help system by entering the help
command. The system will list the command groups as shown below.
INET>help
advance
stp
INET>
For a full list of the commands included in a group, enter the help
command followed by a group name as shown below.
INET>help advance
config
config
config
enable
disable bsf
show
show
show
show
ping
reboot
INET>
You can also display help for a specific command by entering the
command keyword followed by the Enter key as shown below.
INET>enable
igmp
bsf <5,10,15,20,25>
lacpstate <1-8>
sniffer <1-10> rx <portlist> tx <portlist>
INET>
5-2
I
NTERFACE
help parameters:
port
vlan
fdb
qos
igmp
console
advance command:
ip X.X.X.X
subnet X.X.X.X
gateway X.X.X.X
bsf <5,10,15,20,25>
bsf
ip
mac
version
<host_ip> <#times>
enable parameters:
stp
trkgrp
qdlyb <1-255>
vlan {gvrp}
security <1-10> fdbage
lacp <groupid:1~4>