Table of Contents
Advertisement
U
F
PGRADING
IRMWARE
5. After the file has been downloaded, the console screen will display
information similar to that shown below.
$$$ Download IMAGE ....O.K !!!
$$$ Update firmware .............................................
...................................................................
...................................................................
...................................................................
.............................
$$$ Update firmware ....O.K !!!
$$$ Note: console baudrate of new image is 9600bps..
$$$ Reboot .....
Change the baud rate back to 9600 bps. When using Windows
HyperTerminal, disconnect
6. Then press Enter to open the Log-on screen.
For details on managing the switch, refer to the appropriate chapters in
this manual.
B-2
, set the baud rate, and reconnect
S
M
C
User Interface
(c) TigerSwitch 10/100
username:
password:
.
Advertisement
Table of Contents
