Configuring The Aggregator Setting - SMC Networks SMC6709L2 Management Manual

C I
ONSOLE NTERFACE

Configuring the Aggregator Setting

First use the Port Configuration page to create trunk groups (page 4-16),
and then use the Aggregator Setting page to enable LACP and specify the
maximum number of active ports.
Field Attributes
• Group – Specifies the LACP trunk group.
• LACP – Set this field to "Enabled" when configuring a dynamic trunk.
• LACP Work Port Num – Specifies the number of active ports. If the
number of active ports is less than the number of assigned members,
excess ports will be placed in standby mode and only brought into
service if an active link fails.
Console – Click Protocol Related Configuration=>LACP=>Aggregator
Setting. Select the required trunk group, enable LACP, enter the number
of active ports, and then save your settings.
actions->
Arrow/TAB/BKSPC = Move Itemem
4-48
TigerSwitch 10/100 :
=====================
Group
------------------------------------------
Trk1.
<Edit>
Select the action menu.
Quit = Previous menurl+Enter = Select Item
LACP Group Configuration
LACP LACP Work Port Num
Enabled 2
<Save> <Quit>