Table of Contents
Advertisement
TROUBLESHOOTING
Problem
No pulse output
Output pulses incorrect
Jumpy reading
Seametrics • 253.872.0284
Probable Cause
Below minimum flow cutoff
Empty pipe
No power
Incorrect depth setting
Pipe not full
Not enough straight pipe
Fluctuating flow rate
Fluctuating around low flow cutoff
Not enought straight pipe
Things to Try...
Check velocity vs. pipe size (see page 8)
Check plumbing
Check connections
Check depth setting (see page 7)
Refer to installation recommendations
(see pages 5 and 10)
Refer to installation recommendations
(see pages 5 and 9)
Refer to installation recommendations
(see pages 5 - 10)
Check velocity vs. pipe size (see page 8)
Refer to installation recommendations
(see pages 5 and 9)
Page 15
IP100/200 SERIES INSTRUCTIONS
seametrics.com
Advertisement
Table of Contents
Need help?
Do you have a question about the IP100 Series and is the answer not in the manual?