Easy-Pack Tailgate - Mercedes-Benz V-Class Operating Instructions Manual

G
WARNING
The reversing feature does not react:
to soft, light and thin objects, e.g. small fin-
R
gers
over the last 8 mm of the closing movement
R
The reversing feature therefore cannot pre-
vent someone being trapped in these situa-
tions. There is a risk of injury.
When closing, make sure that no-one has any
parts of the body within the closing area.
If someone is trapped:
press the q button on the key or
R
press the closing button on the tailgate or
R
pull the handle on the tailgate
R
Opening and closing
If your vehicle is equipped with a rear window
which can be opened separately, the q but-
ton of the key must be programmed to open/
Y
close the tailgate ( page 87).
The rear window must be closed and the tailgate
unlocked.
X
To open: briefly press button : in the handle
and step out of the swinging range of the tail-
gate.
or
X
Check that there is nobody in the swinging
range of the tailgate and press the q but-
ton on the key for longer than 0.5 seconds.
Automatic operation is started. The tailgate
opens and swings upwards. In addition, you
will hear two warning signals.
You can set the opening angle of the tailgate
Y
( page 88).

EASY-PACK tailgate

X
To close: press closing button ; in the tail-
gate and step out of the swinging range of the
tailgate.
or
X
Check that there is nobody in the swinging
range of the tailgate and press the q but-
ton on the key for longer than 0.5 seconds.
Automatic operation is started and the tail-
gate closes. During closing, closing button ;
flashes and two warning tones sound.
X
To interrupt automatic operation: press
button : in the handle again.
or
X
Press closing button ; in the tailgate again.
or
X
Press the q button on the key again for
longer than 0.5 seconds.
Programming the key button for tail-
gate
If your vehicle is fitted with a rear window which
can be opened separately, you can programme
the q button on the key either to open/close
the tailgate or to open the rear window.
X
Make sure that the tailgate and the rear win-
dow are closed.
X
Turn the key to position 2 in the ignition lock.
X
Press the buttons in the handle of the tailgate
and the handle of the rear window at the same
time for approximately 5 seconds.
After successfully switching the function, the
turn signal lamps flash once.
X
Check function of the q button on the key.
87
Z