Mercedes-Benz V-Class Operating Instructions Manual page 118

Seats
116
Example: standard rear bench seat
Release handle for rear seat anchorage
:
Release handle for front seat legs
;
Seat anchorages
=
i Always carry out unlocking, removal and
subsequent refitting of the seat/berth com-
bination at the marked basic position
Y
( page 108).
X
To remove: if necessary, remove the bed
Y
extension ( page 117).
X
Remove the stowage compartments
Y
( page 313).
X
Make sure that all carriages for fore-and-aft
adjustment engage audibly on both sides.
It should not be possible to move the seat/
berth combination.
X
Fold release handle for rear seat anchor-
age : up.
X
Tilt the seat/berth combination forward using
the upper edge of the seat backrest.
X
Pull release handle for front seat legs ; up.
X
Hold the seat/berth combination by the lower
edge of the seat cushion.
X
Fold the seat/berth combination forwards
and lift it out of seat anchorages =.
X
To fit: remove the stowage compartments
Y
( page 313).
X
Hold the seat/berth combination by the lower
edge of the seat cushion.
X
Place the seat/berth combination into front
seat anchorages = from above and make
sure it engages.
X
Fold release handle ; down towards the
vehicle floor.
X
Fold seat/berth combination back into the
upright position.
The rear seat legs of the seat/berth combina-
tion have engaged correctly if:
the seat legs engage audibly
R
indicator tabs ? on the seat legs are no lon-
R
ger visible and have retracted fully into the
seat legs
The rear seat legs of the seat/berth combina-
tion have not engaged correctly if:
X
Press release handle for rear seat legs :
down until indicator tabs ? have fully retrac-
ted into the rear seat legs.
The rear seat legs of the seat/berth combina-
tion have not engaged correctly again if:
X
Fold the seat/berth combination forwards
again with a degree of force so that the seat
legs engage correctly.
X
Fit the stowage compartments (
Y
page 313).