Cup Holder - Mercedes-Benz V-Class Operating Instructions Manual

Table of Contents

Advertisement

X
To remove: slide lock ; forwards and pull
out cup holder :.
X
To insert: insert cup holder : and slide
lock ; back.
You can remove the rubber mat of the cup
holder to clean it. Wash it with clean and luke-
warm water only.
Cup holders in the rear
Stowage compartment for the cup holder in the
rear compartment (example: left-hand side trim)
Cupholder : is inserted into stowage compart-
ment = of the side trim in the rear compart-
ment.
X
To insert: position cup holder : above stow-
age compartment = so that the "INSIDE" let-
tering on its base ; faces towards the vehi-
cle interior.
X
Insert base ; into the stowage compartment
and press down on both sides.
The cup holder is correctly inserted when:
both sealing rings ? are within stowage
R
compartment =
upper edge A of the base is flush with
R
stowage compartment =.
X
To remove: grasp the bottom of cup
holder : from below and remove by lifting its
base ; out vertically.
Temperature-controlled cup holder in
the rear compartment
G
WARNING
The heating elements of the cup holder can
become very hot. You could burn yourself on
them.
There is a risk of injury.
Never touch the hot heating elements of the
cup holder. Always make sure that the hot
heating elements are out of reach of children.
Never leave children unattended in the vehi-
cle.
Button
:

Cup holder

;
If the temperature-controlled cup holder is used
when the engine is switched off, the starter bat-
tery may discharge. If the on-board voltage is
too low, it might then no longer be possible to
start the engine.
The temperature-controlled cup holder is not
automatically deactivated when the on-board
voltage is low.
The temperature-controlled cup holder can be
used to keep cold drinks cold and hot drinks hot.
When the heating function is used, the metal
insert of the cup holder is heated. For this rea-
son, do not reach into the cup holder insert.
X
Turn the key to position 2 in the ignition lock
Y
(
page 172).
X
To switch on the cooling function: press
button : repeatedly until the blue indicator
lamp on the button lights up.
X
To switch on the heating function: press
button : repeatedly until the red indicator
lamp on the button lights up.
X
To switch off the function: press button :
repeatedly until the indicator lamp on the but-
ton goes out.
The rubber mat can be removed for cleaning.
Wash it with clean, lukewarm water only.
Do not use hard or sharp objects to clean the
cup holder. Use a soft cloth only to clean it.
Cup holder
319
Z

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents