Electrical Connection; Fitting The Machine Undercounter - Westinghouse WSF6606 User Manual

Hide thumbs Also See for WSF6606:
Table of Contents

Advertisement

INSTALLING THE MACHINE
WARNING
WARNING

Electrical Connection

The plug of your machine should be connected to an earthed
outlet that supplies suitable voltage and current If there is no
earthing installation, have a competent electrician carry out
an earthing installation In case of usage without earthing
installed, our company will not be responsible for any loss of
usage that might occur
The indoor fuse current value should be 10-16 A
Your machine is designed for 220-240 V The machine should
not be plugged in during installation
Always use the molded plug supplied with your machine
Running in low voltage will cause a decline in
washing quality
The machine's electrical cable should be replaced by
an authorised service or an authorised electrician only
Failure to do so may lead to accidents
For safety purposes, always make sure to disconnect the
plug when a wash program is finished
In order not to cause an electric shock, do not unplug
when your hands are wet
When disconnecting your machine from the mains supply,
always pull from the plug Never pull the cord itself

Fitting the machine undercounter

If you wish to fit your machine undercounter, check whether
you have sufficient space under your countertop and whether
the wiring-plumbing is suitable to do so
1
To ensure the stability of the dishwasher for an
underbench installation, if the underbench dimension is
greater than 820mm, any gap between the dishwasher
and the underside of the benchtop should be bridged
with a packing piece This may be achieved by wedging
a piece of timber between the dishwasher and the
benchtop as shown
2
If required, remove the worktop as shown in the
illustration
3
To remove the worktop, remove the screws that hold the
worktop which are located at the rear of the machine;
then push the front panel 1 cm from the front towards the
rear and lift it
1
Filler piece cut to
Timber wedging piece
Bench top
2
suit installation
596
3mm gap
598
3
INSTALLATION
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents