Installation - Danfoss TP5001 Range Installation Manual

3.0 Installation

•
First, remove the wallplate from the back of the unit.
GB
GR
•
From the top left hand corner of the wallplate, there must be
TR
clearances of at least 15mm to the right, 15mm to the left,
30mm above and 100mm below in order to mount the plug-in
LV module.
•
Thermostat and Remote Room Sensor:
LT
Fix at a height of approximately 1.5m from the fl oor, away from
draughts or heat sources such as radiators, open fi res or direct
UA
sunlight.
RU
MIN
•
Prior to mounting the unit the 2 DIL switches on the rear of the
unit have to be moved to the required position. The factory
presets are shown below.
6
30m MAX
30
cm
Sw. No.
Keyboard disabled
1
2 Reset disabled
OFF
ON
Keyboard enabled
Reset enabled
TP5001