Wiring - Tp5001; Battery Installation - Danfoss TP5001 Range Installation Manual

3.1 Wiring - TP5001

M 230V Models
N L

3.2 Battery Installation

When installing the batteries in the TP5001 and TP5001 RF please
ensure that the correct polarity is observed as per the markings on
the inside of the battery compartment.
Important: After installing the batteries press and release the RESET
button to start the unit. The display may appear blank until this is
done. Once the button is released the display will appear. All date,
time, programming and override settings are maintained for the life
of the product.
!
Some existing thermostats will have a Neutral and/or Earth wire connected. These
are not required by the TP5001 (battery models) and must NOT be connected to
any TP5001 terminals. Instead they should be made electrically safe and coiled in
the recess at the back of the TP5001.
Models with remote sensor inputs
TP5001A and TP5001MA incorporate an input which can be used to
connect one of the following:
1) remote room temperature sensor (sold as accessory).
2) limit sensor, for example, fl oor temperature sensor (sold as
accessory).
3) window contacts, card reader contacts or teleswitch contacts.
See Installer Advanced Programming Options for set-up
instructions.
Danfoss Heating
D E
S1 S2
Remote Sensor
(A version only)
Output Connections,
all hard wired models
1 2 3
GB
GR
TR
LV
LT
UA
RU
7