Installation - Step By Step; Preparation; Installation Of Living Connect - Danfoss living connect Installation And User Manual

3. Installation - step by step

3.1 Preparation

living connect® is supplied with adapters for Danfoss
UK
RA valves and valves with M30X1.5 (K) connections
(014G0002), two alkaline AA batteries and a 2 mm
TR
Allen key.
SI
Inserting the batteries
Remove the battery cover and insert
HR
the two batteries.
Ensure that the batteries are correctly
inserted. M must flash on the display before
installation, if this is not the case, see reinstallation
mode page 10.
3.2 Installation of living connect®
1. Start by mounting the the adapter.
2. Tighten the RA adapter using the
Allen key.
Tighten the K adapter by hand
(max. 5 Nm).
3. Screw the thermostat onto the
adapter and hand-tighten (max.
5 Nm).
4. Press and hold
6
for approx. 3 seconds to fix the thermostat.
RA K
2mm
Key
living connect®