Configuring Network Address Translation; Overview Of Nat - SMC Networks Barricade SMC7401BRA User Manual

2-port adsl router with built-in annex a adsl modem
Hide thumbs Also See for Barricade SMC7401BRA:
Table of Contents

Advertisement

C
ONFIGURING
A
This section provides an overview of Network Address Translation
(NAT) and instructions for modifying the default configuration on
your device.

Overview of NAT

Network Address Translation is a method for disguising the
private IP addresses you use on your LAN as the public IP
address you use on the Internet. You can define NAT rules
that specify exactly how and when to translate between
public and private IP addresses.
Definition:
In a typical NAT setup, your ISP provides you with a single public
IP address to use for your entire network. Then, you assign each
computer on your LAN a unique private IP address. (Or, you define
a pool of private IP addresses for dynamic assignment to your
computers, as described in Configuring Dynamic Host Configuration
Protocol.) On the ADSL Barricade, you set up a NAT rule to
specify that whenever one of your computers communicates with
the Internet, (that is, it sends and receives IP data packets) its
private IP address - which is referenced in each packet - will be
replaced by the LAN's public IP address.
DDRESS
A private IP address is created by a network
administrator for use only on a LAN, whereas a
public IP address is purchased from the Internet
Corporation for Assigned Names and Numbers
(ICANN) for use on the Internet. Typically, your
ISP provides a public IP address for your entire
LAN, and you define the private addresses for
computers on your LAN.
N
ETWORK
T
RANSLATION
61

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Barricade SMC7401BRA and is the answer not in the manual?

Table of Contents