Configuring The Adsl Barricade; Logging Into The Adsl Barricade - Quick Configuration Page - SMC Networks Barricade SMC7401BRA User Manual

Note:

Configuring the ADSL Barricade

This section provides you instructions on how to log into the
program of the ADSL Barricade and how to configure basic
settings for your Internet connection. Your ISP should provide
you with the necessary information to complete this step.
Logging into the ADSL Barricade -
Quick Configuration Page
The ADSL Barricade provides a preinstalled software program
called Configuration Manager which enables you to configure
the operation of the device via your Web browser. The settings
that you most likely need to change before using the device
are grouped onto one single [Quick Configuration] page.
Follow these instructions to configure the device settings.
1. At any PC connected to the ADSL Barricade via Ethernet or
USB, open your Web browser, and type the following URL
in the address/location box: 192.168.1.1/setup. Username/
Password: smc/smcadmin.
2. When you press [Enter], the page shown in Figure 2 should
appear (see section Troubleshooting on page 181, if you
receive an error message or if the page does not appear).
Your PCs must have IP addresses that place them
in the same subnet as the ADSL Barricade's LAN port.
If you manually assign IP information to all your LAN
PCs, you can follow the instructions in Configuring the
LAN Ports to change the LAN port IP address
accordingly.
Configuring the ADSL Barricade
23