SMC Networks Barricade SMC7401BRA User Manual page 151

Configuring IP Filters and Blocked Protocols
3. Specify the [Protocol] = [TCP] and enable the [Store State]
setting.
4. Select the [TCP Protocol], then specify a [Dest Port] = [80],
which is the well-known port number for web servers.
5. Enable the rule by clicking the radio button at the top
of the page.
6. Click [Submit] to create the rule.
7. On the [IP Filter Configuration] page, set the [Security Level:]
to the same level you chose for the rule, and set both
the [Private Default Action:] and the [Public Default Action:]
to [Accept].
8. Click [Submit], and commit your changes. Figure 51 shows
the configuration for this rule. The specified computer will not
be able to access the Web, but will be able to access FTP
Internet sites (and any others that use destination port
numbers other than 80).
Example 2
Blocking Telnet accesses to the ADSL Barricade:
1. Add a new rule for packets incoming on the [ppp-0] interface.
2. Specify that the packet must contain the TCP protocol, and
must be destined for port 23, the well-known port number
used for the Telnet protocol.
3. [Enable] the rule by clicking the radio button at the top
of the page.
150