Linear Encoder Pcb; 2-1-10.The Keyboard Pcb; Ink Sensor Pcb; 2-1-13.Take-Up Motor Pcb - MIMAKI TextileJet Tx2-1600 Series User And Maintenance Manual

2-1-9. Linear encoder PCB

This board, located on the back of the slider, reads the linear scale.
2-1-10. The KeyBoard PCB
A 16 character x 2 line LCD, an LED that indicates +5V supply and 11 tact switches are
mounted on the K/B PCB. It is connected to the main PCB via the K/B cable.

2-1-11. Ink Sensor PCB 1

The ink sensor PCB 1 is mounted on the Y-motor inside the right cover. It passes on signals
among the ink cartridge presence/absence sensors for ink cartridges, ink end sensor and main
PCB.
2-1-12. Ink Sensor PCB 2
Sensor PCB 2 is on the left-hand side plate ; it relays signals among the ink cartridge presence/
absence sensors for ink cartridges, the ink end sensors and the main PCB.
2-1-13. Take-up motor PCB
This board, located in the take-up device, drivers the motor by receiving the power from the
IO PCB. The forward or reverse rotation of the take-up motor can be selected using a switch.
2-1-14. Centering PCB
The centering PCB, located in the feeding unit PCB, turns the motor with power supplied
from the IO PCB. Only at initialization, the motor can be started up by a switch.
2-1-15. Centering Sensor PCB
The centering sensor PCB, located in the centering sensor unit, relays signals from two reflected
type photosensors.
2-1-16. ID contact PCB
The ID contact PCB is for an ink cartridge.
– 2.13 –