Table of Contents
Advertisement
Others
Precautions
On Safety
• Check the operating voltage before operation.
Operate the unit only with a power source specified in
"Specifications."
• Stop operation immediately if any liquid or solid
object falls into the cabinet. Unplug the unit and have
it checked by qualified personnel.
• Unplug the unit from the wall outlet if you will not be
using it for a long time. Disconnect the power cord by
grasping the plug. Never pull the cord itself.
• Do not disassemble the cabinet. Refer servicing to
qualified personnel only.
Caution
Paper cutters are mounted in the unit. When loading
paper, be careful not to touch the paper cutters. Touching
the paper cutters may cause injury.
On the Printer Carriage
Do not carry or move the unit when the paper roll is
placed in the unit. Doing so may cause a malfunction.
On Installation
• Place the unit on a level and stable surface.
If you use the unit with placed on an uneven surface,
malfunction of the unit is likely to occur.
• Do not install the unit near heat sources. Avoid
locations near radiators or air ducts, or places subject
to direct sunlight or excessive dust, humidity,
mechanical shock or vibration.
• Provide adequate air circulation to prevent heat build-
up. Do not place the unit on surfaces such as rugs,
blankets, etc., or near materials such as curtains and
draperies.
Caution
To prevent internal heat built-up, maintain sufficient
space around the printer (at least 10 cm (4 in.)). Do not
obstruct the ventilation holes on the right and left sides
of the printer and on the rear panel.
32
Precautions
• If the unit is suddenly taken from a cold to a warm
location, or if ambient temperature suddenly rises,
moisture may form on the outer surface of the unit
and/or inside of the unit. This is known as
condensation. If condensation occurs, turn off the unit
and wait until the condensation clears before operating
the unit. Operating the unit while condensation is
present may damage the unit.
About the battery
This unit has a battery for the clock operation inside.
The battery is a consumable part that will need periodic
replacement.
When operating at room temperature, the normal
replacement cycle will be about 5 years. However, this
replacement cycle only represents a general guideline
and does not imply that the life expectancy of this part is
guaranteed. For details on part replacement, contact
Sony service or your dealer.
Cleaning the Cabinet
Note
Before cleaning the printer, be sure to turn off the power
and disconnect the power cord.
When the cabinet becomes dirty
When solvents such as benzene or thinner, or acid,
alkaline or abrasive detergent, or chemical cleaning
cloths are used on the printer surface, the surface finish
may be damaged. Take care with respect to the
following:
• Clean the printer surface with a 50 to 70 v/v%
concentration of isopropyl alcohol or a 76.9 to
81.4 v/v% concentration of ethanol.
• Stubborn stains may be removed with a soft cloth such
as a cleaning cloth lightly dampened with mild
detergent solution and then cleaned using the above
chemical.
• Do not use unnecessary force to rub the printer surface
with a stained cloth. The printer surface may be
scratched.
Hide quick links:
Advertisement
Table of Contents
