1
Press the power ON/OFF switch to on.
When paper is not loaded yet, the back light on the
LCD lights in orange and the message "EMPTY" is
displayed.
2
Press the OPEN button to open the door panel.
3
Remove the label from the leading edge of the
paper, pull out about 15 – 20 cm (6 – 8 in) of the
paper, and then set the paper roll in the paper tray.
Note
When installing/removing the paper to/from the
paper tray, be careful not to drop the paper or put
the paper on desk, etc., with the surface of the paper
facing downward.
16
Loading Paper
Remove label and pull out
15 – 20 cm (6 – 8 in).
Load the paper in the orientation shown
in the diagram. Printing is not possible if
the paper is reversed.
Make sure that the paper is set
straight.